TECPEL CL-327A Manual page 14

Low battery:
The dictation flashes in sequence when getting charged.
Note that the battery replacement indicator is driven by directly measuring the battery voltage when the
calibrator is in actual operation. Consequently, the indicator may read differently depending on the battery load
condition if the batteries are too low. If the calibrator will be used under a wide variety of conditions, it is
advisable that the battery replacement indicator be verified under heavy loads.
Connecting the Charger
Warning
 Make sure the voltage of the AC power source matches the rated supply voltage of the Charger, before
connecting the Charger to the AC power source.
Do not use any Charger other than the dedicated Charger from the Company.

 Do not charge non Ni-Cd, Ni-MH batteries or wasted batteries.
Step 1: Make sure the calibrator is turned off.
Step 2: Insert the plug of the optional Charger into the Charger connection jack.
Note
 Turn off the calibrator before connecting or disconnecting the Charger from AC power, plugging in/out the
Charger connection jack.
 Plug out the Charger from the Charger connection jack of the calibrator when discharging.
 Do not charge the calibrator without any battery in.
Turning On the Power
14