Table of Contents
Advertisement
im Vertrieb von
Example 1a: Create a set of ties in enter switch mode
www.camboard.de
CAMBOARD Electronics
1.
Only one video input can be tied to an output, but multiple outputs can be
tied to a single input.
If a tie is made between an input and an output, and the selected output
2.
was previously tied to another input, the older tie is broken in favor of the
newer tie.
3.
To indicate current ties, the associated input button lights green (both
modes) and all the associated output buttons light green (enter switch
mode) or red (quick switch mode) when either an input or output button
is selected.
4.
If an input with no tie is selected, only that input's button lights green.
In enter switch mode, as each output is selected, the associated output
5.
button blinks green to indicate a tentative tie. Buttons for output(s) that
were already tied to the input light green steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled
off by pressing the associated output button.
The following steps show an example in which input 5 is tied to outputs 3, 4, and 8
in enter switch mode. Each step shows the front panel indications that result from
your action.
This example assumes that there are no ties in the current configuration.
1.
Press and release the input 5 button (figure 3-5).
INPUTS
1 2 3 4 5 6 7 8
Press and release the input 5 button.
The button lights green.
Figure 3-5 — Select an input
2.
Press and release the output 3, output 4, and output 8 buttons (figure 3-6).
OUTPUTS
1 2 3 4 5 6 7 8
Press and release the output 3, 4, and 8
buttons. The buttons blink green.
= Blinking Button
Figure 3-6 — Select outputs
Tel. 07131 911201
Digital XPoint Matrix Switchers • Operation
Fax 07131 911203
I n p u t # 5
N o S y n c
1 Second
1 2 3 4 5 6 7 8
OUTPUTS
_ _ _ _ _ _ _ _
INPUTS
The LCD displays the input's status (Detected or
No Sync), then the current switch configuration.
See Viewing source status and the current
configuration in this chapter.
CONTROL
ENTER
PRESET
The Enter button
blinks green to
indicate the need to
confirm the change.
ce-info@camboard.de
3-5
Advertisement
Table of Contents
