Extron electronics DXP Series User Manual page 3

im Vertrieb von
Quick Start — Digital XPoint Matrix Switchers
Installation
Step 1
Turn off power to the input and output devices,
and remove the power cords from them.
Step 2
Mount the switcher in a rack or under a table.
Step 3
Connect:
a
Up to 4 or 8 SDI inputs to the Input In (top)
connectors.
b
Up to 4 or 8 SDI displays or other devices to
the Input loop-through (bottom) connectors.
c
Up to 8 or 16 SDI display or other devices to
the Output connectors.
Each output number consists of two
identical SDI outputs.
3a
SDI
Source
1
SDI
3b
Loop-through
Step 4
If desired, connect a control system or computer to
the RS-232/RS-422 port.
5 1
4
9 6
Female
Pin RS-232 Function
1 — Not used
2 TX Transmit data
3 RX Receive data
4 — Not used
5 Gnd Signal ground
6 — Not used
7 — Not used
8 — Not used
9 — Not used
Step 5
If desired, attach an external sync timing device to
the external sync connectors.
Step 6
Plug the switcher, input devices, and output
devices into a grounded AC source, and turn on the
input and output devices.
www.camboard.de
CAMBOARD Electronics
3c
1 SDI
Destination
SDI
Destination
1 5
6 9
Male
RS-422 Function
TX- Transmit data (-)
TX+ Transmit data (+)
RX+ Receive data (+)
RX- Receive data (-)
Gnd Signal ground
— Not used
— Not used
— Not used
— Not used
Tel. 07131 911201
Fax 07131 911203
Definitions
The following terms are used throughout this
manual:
Tie — An input-to-output connection.
Set of ties — An input tied to two or more outputs.
(An output can never be tied to multiple
inputs.)
Configuration — One or more ties or sets of ties.
Current configuration — The currently active
configuration (also called configuration 0).
Preset — A configuration that has been stored. One
preset can be assigned to each input and output
button. Additional presets are available under
RS-232/422 control. When a preset is retrieved, it
becomes the current configuration.
Front Panel Controls
Input and output buttons select and identify
inputs and outputs. The buttons also select
presets.
Enter button saves changes when you change the
configuration.
Preset button saves a configuration as a preset or
recalls a previously-defined preset.
Input and output buttons can hold text or icon
inserts that can be created easily with Extron's
label software.
LCD Displays
To view the status (Detected or No Sync) for a
specific input and then the current configuration,
press and release the button for the desired input.
The LCD displays the source status message for
approximately 1 second and then the current
configuration for approximately 10 seconds. To
check the status of another source, press and
release another Input button. The LCD displays
each output number on the top line and the tied
inputs on the bottom line.
STATUS STATUS
I n p u t # 5 1 2 3 4 5 6 7 8
_ _ _ _
No S y n c 5 5 5
1
Second
ce-info@camboard.de
STATUS
EXTRON
_
DXP 8 8
10
Seconds