Table of Contents
Advertisement
•
If, when you are configuring video and audio ties, the Audio LED blinks and
the Video LED is on after you have selected an input or output, the LEDs
indicate audio breakaway, meaning that the audio ties are not the same as the
video ties for that input.
•
If an input with no tie is selected, only that input's LED lights.
•
As each output is selected, the associated output LED blinks to indicate
a tentative tie until you press the Enter button or the 5-second timeout
expires. LEDs for output(s) that were already tied to the input light steadily.
Outputs that are already tied can be left on, along with new blinking
selections, or toggled off by pressing the associated output button.
•
If you inadvertently press the wrong input or output button, wait
approximately 5 seconds. The input and output button selections time out
and are abandoned.
Example 1: Create a set of video and audio ties
In the following example, input 5 is tied to outputs 3, 4, and 8. The example shows
the front panel indications that result from your actions.
N This example assumes that there are no ties in the current configuration.
1.
Select video and audio for the tie (figure 3-3).
The video LED lights when video is selected.
The audio LED lights when audio is selected.
Figure 3-3 — Select video and audio
2.
Press and release the Input 5 button (figure 3-4).
Press and release the Input 5 button.
1
2
Figure 3-4 — Select an input
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation
Press the button to cycle
through the selections.
I/O
VID
AUD
INPUTS
3
4
5
6
The Input 5 LED lights to indicate that input 5 is selected.
7
8
3-7
Advertisement
Table of Contents
