Switch Modes; Creating A Configuration - Extron electronics DXP Series User Manual

im Vertrieb von
Operation, cont'd
The current configuration and all presets are saved in non-volatile memory. When
power is applied, the last current configuration is retrieved. The previous presets
remain intact.
If an error occurs during the self-test, the switcher locks up and will not operate. If
your switcher locks up on power-up, call the Extron S
Hotline.

Switch modes

The Digital XPoints have two switching modes:
•
•
The current switch mode can be determined by pressing and releasing an output
button. In the enter switch mode, output buttons light or blink green when
selected. In the quick switch mode, the output buttons light red. After
approximately 10 seconds, the buttons return to either unlit or to background
illumination.
Toggle between the two modes as follows (figure 3-4):
Press and
hold for 2
seconds.
Figure 3-4 — Changing switch mode
1.
2.
3.

Creating a configuration

The current configuration can be changed using the front panel buttons. To change
the current configuration, do the following:
1.
2.
3.
www.camboard.de
3-4 Digital XPoint Matrix Switchers • Operation
CAMBOARD Electronics
The enter switch mode, in which selected switch changes take effect only after
you press the Enter button.
The quick switch mode, in which the changes take place on the fly, as you
select them, without the need to press the Enter button.
The switch mode is for ties only. Switch mode has no effect on saving and
recalling presets.
E n t e r
ENTER
— or —
Mo d e
8 Second Timeout
E X T RON
D X P 8 8
Press and hold the Enter button for approximately 2 seconds.
The LCD displays one of two messages: either Enter Mode or Quick Switch.
After approximately 8 seconds, the LCD returns to the default display.
Select the desired input and the desired output(s) by pressing the input and
output buttons.
To clear unwanted outputs, press and release the associated lit output
buttons.
In the quick switch mode, the tie is created immediately.
If in the enter switch mode, press and release the Enter button.
Repeat steps 1 and 2 to create additional ties until the desired configuration is
complete.
Tel. 07131 911201
Fax 07131 911203
3
Sales & Technical Support
Qu i c k
Sw i t c h
ce-info@camboard.de