Table of Contents
Advertisement
Keysight E5072A Network Analyzer
Installation Guide
2
Troubleshooting
This chapter describes the troubleshooting process during start up and the
procedure of the operating system (OS) recovery when the Windows OS has
been damaged.
Troubleshooting during Startup
When you encounter problems during start up, see
saves most of problems.
Table 2-1
Troubleshooting during startup
Symptom
Turning on (|) the standby switch does not
start up the system.
The system starts up, but it automatically
shuts down immediately.
The system starts up, but it enters the
service mode (The status bar at the lower
right of the screen displays SVC in red).
The measurement screen appears after
start up, but the power-on test fails with
Error Message 241 prompting on a red
background in the instrument's
message/warning area at the lower left of
the screen.
Solution
Confirm that the power cable is properly
plugged in.
Confirm that the line switch at the rear
panel is turned on.
Execute the system recovery.
29
Table
2-1. System recovery
Advertisement
Table of Contents
