Step 5: Install Akd Workbench And Configure The Drive - National Instruments C Series Getting Started

Hide thumbs Also See for C Series:

Table of Contents

Step 5: Install AKD WorkBench and Configure the Drive

AKD WorkBench is available on the CD that came with the AKD servo drive and is also

available from

ni.com/updates

drive settings with AKD WorkBench.

Insert the AKD WorkBench CD in the CD-ROM drive on your PC.

Double-click

Full Setup.exe

Follow the onscreen instructions to complete the installation.

Launch the AKD WorkBench software by clicking the AKD WorkBench icon on the

desktop, or by selecting Start»All Programs»Kollmorgen»AKD WorkBench.

Select the drive to configure from the list and click Connect.

If the drive is not in the list, refer to the

Note

this document for possible solutions.

20 | ni.com | Getting Started with NI 9514/16 Modules and AKD Servo Drives

. Complete the following steps to install and configure the

to launch the installer.

Tips and Troubleshooting

section of

Table of Contents

Do you have a question about the C Series and is the answer not in the manual?

9514 9516