Board Swapping (Hot Swap T1/E1/Pri Nic) - Avaya CS700 Installing Instructions

6. Lock the black tabs to fully engage the card.
7. Tighten the captive screws.

Board Swapping (Hot Swap T1/E1/PRI NIC)

Note:
If there is only one NIC, it cannot be hot-swapped. Use the procedure in
Note:
"Swapping Cards (Normal Shut down)
swap the card.
!
Important:
T1/E1/PRI NICs can only be hot swapped if:
Important:
- The feature is provided.
- The replacement cards are NS301 revision AC or later. Examine the label on the
replacement card and verify that it is revision AC or later before inserting it.
The cards are physically similar enough that it is hard to identify the model and
revision. A distinctive label has been applied to NS301 revision AC and later cards.
!
CAUTION:
Only NS301 revision AC or later NIC cards can be inserted while the system is
CAUTION:
powered on. Inserting older versions while power is applied may cause faults in
the bridge.
Power Up and Initial Testing
on page 64" to shut the system down and
Label
Issue 1 July 2006 67