Operation
Placing the UPS in Operate Mode
Press the On button (1) to transfer the system to Operate mode.
Figure 2-4: UPS On button
Initiating a Self-test
To initiate a self-test, press and hold the Test/Alarm Reset button (1) for three seconds.
Figure 2-5: Test/Alarm Reset button
Because a portion of the self-test requires battery power, the self-test will not be initiated if
the batteries are less than 90 percent charged. If the UPS detects a problem, LED 4 will be
solid red (see Figure 2-3), and the UPS sounds an audible alarm.
NOTE: See Chapter 5, "Troubleshooting," for information on what to do if the self-test detects a
problem.
2-6
1
1
Compaq Uninterruptible Power System R12000 XR User Guide