Nice ALTO Instructions And Warnings For Installation And Use page 41

4
d
a
Connection
5
cascade
6
B
C
D
TABLE 2 - Electric cable specifications
Connection
A - Power line
B - FLASH Flashing light output
C - Radio aerial
D - BUS input/output (note 4)
E - STOP Input
F - SbS Input
G - Motor output without control unit
Note 1 - External cable diameter: Maximum 11 mm.
Note 2 - If the po er cable is longer than 30 m, a cable ith a larger section is required (e.g. 3x2.5mm²) and safety earthing is necessary in the
vicinity of the automation.
Note 3 - For these connections (D, E, F) a single cable ith multiple internal ires may be used. This enables grouping of multiple connections:
for example, the STOP and SbS inputs can be connected to the accessory device ith a cable of 4 x 0.5 mm².
Note 4 - For information on ECSBus technology, refer to paragraph 3.3.3
WARNING! – The cables used must be suited to the installation environment: for example, for indoor environments cable types
H03VV-F are recommended, and for outdoor environments, cable types H07RN-F.
5 – English
c
f
Connection
Star
G
Type of cable (minimum section values)
cable 3 x 1,5 mm² (note 1)
cable 2 x 0.5 mm²
RG58 shielded cable type
cable 2 x 0.5 mm²
cable 2 x 0.5 mm²
cable 2 x 0.5 mm²
cable 3 x 1 mm²
c
e
Connection
"combined"
D
(ref. fig. 6 and paragraph 3.3.4)
Max. admissible length
30 m (note 2)
20 m
20 m (less than 5 m recommended)
20 m (note 3)
20 m (note 3)
20 m (note 3)
10 m
E
b
f
E F
A