CHAINTECH 7NJS Ultra User Manual page 48

Chapter 3
Promise RAID:
This item allows you to Enabled / Disabled the onboard Promise RAID
function.
（3） Super IO Device:
This section provides information on setting Super I/O device. By choosing
the Integrated Peripherals option from the CMOS Setup Utility menu (Figure
3-5), the screen below is displayed. This sample screen contains the
manufacturer's default values for the motherboard.
Press [Enter] to enter the sub-menu, which contains the following items for
advanced control:
Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install an add-in FDC or the
system has no floppy drive, select Disabled in this field.
Onboard Serial Port 1/2:
Select an address and corresponding interrupt for the first and second serial
ports. Available options are [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4],
[2F8/IRQ3], [Disabled], and [Auto].
UART Mode Select:
This function allows you to select an operating mode for the second serial
port. (Normal RS-232C serial port / IRDA / SCR / ASKIR 0.57-MB/sec
infrared port)
Onboard Parallel Port:
Select a logical LPT port address and corresponding interrupt for the
physical parallel port.
Parallel Port Mode:
Select an operating mode for the onboard parallel (printer) port. Select SPP
unless you are certain your hardware and software support one of the other
available modes.
ECP Mode Use DMA:
This item automatically specifies a DMA channel 1 or 3 for the parallel port
when it is set to [ECP] or [ECP+EPP] mode.
Game Port Address:
This item disables or assigns the address of the Game port. Available
options are [201] and [209].
Midi Port Address:
This item disables or assigns the address of the Midi port. Available options
are [300] and [330].
42 7NJS Ultra User's Guide