Transport, Packaging And Storage; Safety Notes; Transport Inspection; Packaging - Eaton CEAG ZB-S Mounting And Operating Instructions

Central battery system
Table of Contents

Advertisement

5 Transport, Packaging and Storage

5 Transport, Packaging and Storage

5.1 Safety Notes

WARNING! RISK OF INJURY!
There is a risk of injury when transporting or loading
due to falling parts .
ATTENTION!
Damage to Property!
Batteries will be destroyed or damaged by improper
transport .
The following safety notes have to be observed:
Never lift loads over person´s head.
O
O
Always move battery with great care and attention.
O
O
Only use lifting accessories and hoisting devices with
O
O
enough loading capacity.
Always handle and store the ZB-S system upright (see
O
O
markings and „do not tilt" sign on the pack)
Avoid ingress of dust and moisture during handling.
O
O
Ensure that all transport routes
O
O
are clear (sufficient width and headroom for all
O
O
transport movements),
provide enough room for persons to take evasive
O
O
action if loads tip over or slip,
have sufficient loadbearing capacity (for the load,
O
O
transport packaging and handling equipment)
could not overstrain the used transport equipment in
O
O
regard of increase and constitution of underground.
Use only
O
O
handling equipment (e. g. pallet trucks, fork trucks, etc.)
O
O
slinging equipment (lifting beams, chains, ropes, etc.)
O
O
and securing equipment (chocks, timbers, guide/
O
O
tensioning/securing ropes, etc.)
that are in technically perfect condition and of
O
O
adequate loadbearing capacity.
Follow all information shown on the transport packaging
O
O
and/or on the device/control cabinet relating to
handling, transport position, slinging points.
The equipment must be handled by persons familiar
O
O
with the appropriate procedures and signals and able to
carry out the handling operations properly and with due
regard to safety and hazard procedures.
62
Mounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de
Batteries
For battery handling and storage please follow the battery
manufacturer´s directions and the instructions about the
battery cabinets.

5.2 Transport inspection

Check delivery on receipt for completeness and for
transport damages, immediately. If external damage is
detected do not accept the delivery, except under protest.

5.3 Packaging

If no return - agreement exists for packing material
separate it according to type and size for further use.
ATTENTION!
Packing material has to be recycled in an environmen-
tally friendly way and according to the local provi-
sions governing disposal . If necessary, commission
special recycling company .
Observe notes for handling printed on the packing material!

5.4 Storage

Keep packages closed up to mounting and observe the
external marked arrangement and storage notes.
Store packages under the following conditions:
Not to be stored outside
O
O
Keep dry and dust-free
O
O
The storage location should be clean and tidy
O
O
The time of storage should be as short as possible
O
O
(FIFO - method)
It is forbidden to stack one pallet/system above the
O
O
other
Attend for batteries:
When storing batteries as spare parts the information
in the ‚Battery cabinets' / ‚Battery rack' installation and
operating instructions must be observed.
If the mains supply to the ZB-S central battery system
is interrupted for more than three days, then the battery
circuits must be isolated (by removing the battery fuse).
This should be done by qualified electricians.
Please oberserve additionally the operation instructions
for battery cabinets and/or battery racks.
NOTE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents