Event Printer Pd3 - Eaton CEAG ZB-S Mounting And Operating Instructions

4 Construction and Function
CEAG Notlichtsysteme GmbH attend on downawards
compatibility at the development and further development
of the modules for one system family (in this case SKU
modules for the system ZB-S) in view of the control soft-
ware for module, their use and handling.
Please attend for safety the attributiv technical
O O
documentation of the modules by operation of the
modules in acutal level of development as well as by
operation of modules in older levels of developments.
In case of doubt please contact the customer service of
O O
CEAG Notlichtsysteme GmbH.
The display at the controllers CU CG-S implement
O O
the active SKU-module of the particular type series;
that means a SKU-module appears e. g. during the
registration with a correct marking on the graphic
display of the controller.
Similar fact also apply for superior monitoring system,
O O
parameterisation-software and CG-modules with
individual monitoring.

4.4.7 Event printer PD3

Description
The event printer PD3 can apply as an option as from
controller software version F .
The device can be placed user-defined on a free storage
space on the subrack (BGT).By default the storage places
7 and 8 on BGT1 are provided for. Mains supply of the
printer and the communication with the controller CU
CG-S occur via the (rearward) contact of the device and
the subrack.
When the printer is logged in and activated via the
controller software all entries which are stored for the log
book are printed on the inserted paper reel.
Configuration
By pressing the Service-Button the protocol printer
for the active plug place on the BGT is registered and
activated. Further settings occur via control software of
the controller CU CG-S (as from version F) over the menu
«Mains settings / Setup printer».
Operation
Button LF at the front panel of the device for paper
O O
feed (Line Feed).
Replacement of paper reel and the ribbon respectively
O O
To replace the paper reel of the printer or the ribbon the
event printer PD3 must be removed from the subrack. You
can find detailed information in the operation instruction
attached to the device.
48 Mounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de
NOTE
Prior to this, the event printer must be logged out from
the cabinet over the controller CU CG-S!
This happens over the menu «Setup printer» in the menu
«Mains settings» with the selection «not installed».
Activate/deactivate printer
O O
This happens over the menu «Main settings / Setup
Printer» of the controller software CU CG-S.
Indicators
Light emitting diode «Druckt / busy»
O O
The LED lights up when the printer executes a print
procedure.
NOTE: