Pb Lead-Acid Battery Program - Skyrc IMAX B6 V2 Instruction Manual

Pb Lead-acid Battery Program

Pb Lead-Acid Battery Program
Pb (Lead-Acid):
This program is only suitable for charging
BATT/PROGRAM
Pb(lead-acid) batteries with nominal voltage
Pb BATT
ranging from 2 to 20V which are significantly
different from NiMH/NiCd batteries. Pb
batteries are suggested to charge with a low
current of 0.1C and cannot be used for fast
charging. Please follow the instructions
provided by the battery manufacturer.
The B6 V2 offers the following Pb charge
modes: Charge, AGM, COLD and Discharge.
Pb Charge Mode:
After selecting the correct battery type, use the INC or DEC button to
change it to the "CHARGE" mode.
Press the START button and the amp rate value will begin flashing.
Use the INC or DEC buttons to adjust the value to the desired charge
rate. The amp rate should be set to 1/10th of capacity. For example, if
you are charging a 20Ah battery the charge rate should be set to 2A.
Follow the instructions provided on your battery when setting the amp
rate.
Press the START button again and the
Normal nominal battery pack voltage will begin
Pb Charge
flashing. Use the INC or DEC button to set the
2.0A 12.0V(6P)
voltage and the number of cells.
Press and hold the START button for 3
seconds to start charging.
P-6 1.5A 13.56V
CHG 00:02:22 Once charging has commenced, the charger
will display the following real-time information:
battery type, charging current, battery voltage,
P-6 1.5A 13.56V
working mode, elapsed time and charged
CHG 00106mAh
capacity.
When charging is complete, the screen will
P-6 FULL 13.62V
read "FULL" and the charger will emit a ringing
CHG 00106mAh
sound.
· 22
Pb AGM Mode:
After selecting the correct battery type, use the INC or DEC button to
change it to the "AGM CHARGE" mode.
Press the START button and the amp rate value will begin flashing.
Use the INC or DEC buttons to adjust the value to the desired charge
rate. The amp rate should be set to 1/10th of capacity. For example, if
you are charging a 20Ah battery the charge rate should be set to 2A.
Follow the instructions provided on your battery when setting the amp
rate.
Pb AGM CHG
1.5A 12.0V(6P)
P-6 1.5A 13.56V
AGM CHG 00:02:22
P-6 1.5A 13.56V
AGM CHG 00106mAh
P-6 FULL 13.62V
AGM CHG 00106mAh
B6 V2 B6 V2
Pb Lead-acid Battery Program
Press the START button again and the
nominal battery pack voltage will begin
flashing. Use the INC or DEC button to set the
voltage and the number of cells.
Press and hold the START button for 3
seconds to start charging.
Once charging has commenced, the charger
will display the following real-time information:
battery type, charging current, battery voltage,
working mode, elapsed time and charged
capacity.
When charging is complete, the screen will
read "FULL" and the charger will emit a ringing
sound.
23 ·