Skyrc IMAX B6 V2 Instruction Manual page 8

Lithium Battery Program
(1) A memory profile is available for setting and storing pertinent
information for up to 10 different program sets. Once a battery
program is stored into memory, it will be retained until changed
again manually. Recalling a program memory number makes the
charger instantly ready to go!
(2)
If you do not wish to use the battery program memories, this
charger can be manually set before each use.
The following flowchart shows how the program is set manually:
BATT/PROGRAM Select
BATT/PROGRAM
Press INC and DEC to go through all the
LiPo BATT
programs and press START/ENTER to enter
LiPo BATT Program.
START/ENTER
Mode Select
LiPo BALANCE CHG
Press INC and DEC to go through all the
2.0A 11.1V (3S)
modes and press START/ENTER to enter
LiPo Balance Charge Mode.
START/ENTER
Battery Setting
LiPo BALANCE CHG
Press START/ENTER, the present value will
2.0A 11.1V (3S)
start to blink. Press INC and DEC to change
the value and press START/ENTER to
START/ENTER
confirm your setting.
LiPo BALANCE CHG
At the same time, the battery pack's cell
2.0A 11.1V (3S)
count will start to blink, press INC and DEC
to change the value and press START/
START/ENTER
ENTER to confirm your setting.
LiPo BALANCE CHG
Program Start
2.0A 11.1V (3S)
Press and hold START/ENTER for 3
START/ENTER
seconds to start the program.
> 3 Seconds
· 14
(LiPo/LiFe/Lilon/LiHV)
B6 V2
Lithium Battery Program
BATTERY CHECK
The charger is detecting the battery cell.
...............
R shows the number of cells detected by the
charger and S is the number of cells set by
R:3SER S:3SER
you on the previous screen. If the two numbers
CANCEL(STOP)
are not identical, press STOP to go back to
the previous screen to recheck the number of
cells of the battery pack that you set before
going ahead.
R shows the number of cells detected by the
R:3SER S:3SER
charger and S is the number of cells set by
CONFIRM(ENTER)
you on the previous screen. If the two
START/ENTER
numbers are identical, press START/ENTER
to start the charging process.
50% 10.20V
C 2.0A 00301mAh
Charging Status Monitor
During charge process, real-time status will be
shown as seen on the left. Print INC or DEC,
more status will show on the screen.
FULL 12.61V
0.0A 00568mAh
Program Complete
Once the battery is fully charged, the screen
will read "FULL" and the charger will emit a
FULL 12.61V
ringing sound. The charger also displays
0.0A 00:05:25
battery voltage, charged capacity and elapsed
time.
Program Stop
During the charging
process, press STOP
to stop the charging
process.
Please scan and watch the tutorial video about
how to charge LiPo battery in balance mode.
Video
Tutorial
B6 V2
(LiPo/LiFe/Lilon/LiHV)
15 ·