Pb Lead-Acid Battery Program - Skyrc T100 Instruction Manual

PB LEAD-ACID BATTERY PROGRAM

Additional NiMH/NiCd Process Information:
During the NiMH/NiCd battery charging process the T100 can display avariety of
information. Using the INC or DEC buttons, you can also view the following.
information:
NiMH Sensitivity
D.Peak 4mV/CELL
Safety Timer
ON 120min
Capacity Cut-Off
ON 5000mAh
Pb Lead-Acid Battery Program
Pb (Lead-Acid):
BATT/PROGRAM
Pb BATT
Pb Charge Mode:
After selecting the correct battery type, use the INC or DEC button to change it to the
"CHARGE" mode.
Press the START button and the amp rate value will begin flashing. Use the INC or
DEC buttons to adjust the value to the desired charge rate. The amp rate should be
set to 1/10th of capacity. For example, if you are charging a 20Ah battery the charge
rate should be set to 2A. Follow the instructions provided on your battery when
setting the amp rate.
· 16
Delta Peak Voltage
Sensitivity setting
Safety timer
setting
Capacity limit
setting
This program is only suitable for charging 6/12V Pb(lead-acid)
batteries which are significantly different from NiMH/NiCd
batteries. Pb batteries are suggested to charge with a low
current of 0.1C and cannot be used for fast charging. Please
follow the instructions provided by the battery manufacturer.
The T100 offers the following Pb charge modes: Charge, AGM
and COLD.
12.56V
T100