Seagate Exos E 4U106 Hardware Installation And Maintenance Manual page 58

Arrow "D" pointing upward
Figure 50 Rear view: CMA installed correctly
13. Insert IOMs as described in
14. Install the crossbar (bar with a blue thumbscrew at each end), which helps to stabilize the rails.
Figure 51 Crossbar installed on the 4U106 enclosure between 2 rails
15. Install the shipping screws (optional step required only for preventing non-operating transportation
shock/vibration)
Figure 52 Shipping screw installed
The figure above identifies an installed shipping screw using a red arrow. A shipping screw installs above each
of the crossbar thumbscrews as shown in the enclosure rear panel view included above this step.
58 Installation
"King Slide" name visible on the top of the cable holders
"Installing an IOM" (page
Shipping screw
87)".