Seagate Exos E 4U106 Hardware Installation And Maintenance Manual page 49

3. Insert the key holes present on the right inner rail into the T-pins present on the right sidewall of the enclosure,
and slide the right inner rail towards the enclosure back until it locks itself into the slots (see
4. Make sure that the screw holes (quantity 5) on the left inner rack rail are aligned to the respective screw holes
present on the left side of the physical enclosure.
5. Using the quantity-5 M3 screws provided, secure the right inner rack rail to the right side of the physical
enclosure. Torque each screw to 1.36 N-m (12 lbf-in).
Adjusting the rack rails
1. Measure the rail-span depth distance from rear rack post to front rack post, and record this dimension.
2. Take the left outer rail subassembly (P/N: 727648200) in hand; then rotate the middle slide release, and fully
extend the middle slide.
3. Unscrew and remove the quantity-4 rail kit rear-mounting bracket screws to adjust the rack post-to-post
distance for the left rail subassembly.
Middle slide – fully extended
(Slide release latch identified above)
Figure 33).
Middle slide release detail
Rackmount rail kit 49