Seagate Exos E 4U106 Hardware Installation And Maintenance Manual page 44

Table 7 Outer rail kit package fasteners
Item
no.
4
5
6
Table 8 Inner rail kit package fasteners
Item
no.
7
WARNING! Do not attempt to install the enclosure into the rack with drives preloaded into drive slots. The
enclosure should be installed without drives during rackmount installation. Unload drives (if installed) to an
ESD-protected area and label them. Failure to observe this Warning and the following guidelines could result in
serious injury. Although you can further lighten the enclosure by removing FRUs, it is not necessary to do so.
This procedure describes adjustment and installation of left and right rail subassemblies, followed by installation of
the 4U106 enclosure into the rack.
Enclosure installation involves interrelated steps and product-kit subassemblies. The rail kit comprises left and
right rail subassemblies that attach to the 4U106 enclosure and the rack. The cable management arm (CMA)
comprises subassemblies that attach to the 4U106 enclosure, rails, and rack.
44 Installation
Quantity Description
10 Screws, 10-32x3/4" length, Truss head
(Screws to attach outer rails to the rack
posts)
2 Screws, M5 0.8x4mm length
(Screws to lock a chassis to rack posts
when transporting the rack with the
chassis installed)
4 10-32, Cage nut, Retainers
(Nuts to retain quantity 4 of Item 4
screws)
Quantity Description
10 Screw, M3-05x2.75" length, Torx head,
Low Profile
(Screws to attach inner rails to the
chassis)
Required tool
#2 Phillips screwdriver (12"
length)
#2 Phillips screwdriver (6"
length)
None
Required tool
T10 screwdriver (6" length)