Gent System 800 Installer Manual page 68

Any service and maintenance work on the panel or system must be carried out by a
trained maintenance engineer from the fire alarm servicing organisation.
Message displayed Description and checks
Panel earth fault
Panel in customer
engineering mode
Panel in fire -
Access denied
Password must be
at least 4
characters
Regulated dc
supply high
Regulated dc
supply OK
Reset successful
Security mode
Settings saved
Settings updated
Sounder disabled
Sounder enabled
Split loop
allocation
Split loop
System clock
System clock not
System fault -
processor failure
System fault
Too many devices
Unknown device
Unsaved data!!
Enter to Save or
configuration
Weekly fire test
due today
Zone disabled
Zone enabled
Zone test fire
68
796688 (4188-657)_i2 _06/03
There is an earth fault at the panel.
Check the earth connections to the panel.
The panel is now in customer mode that is at access level 3.
mode
Panel in
The panel is now in engineering mode, that is at access
level 4.
Access to the functionality requested is not possible while the
panel is in fire condition.
The new password must be at least 4 character long.
The regulated DC power supply on the electronic module is
too high.
The regulated DC power supply is OK.
A manual fire reset from the panel was successful.
The security mode has been entered to allow access to menu
entered
options under level - 2.
The changes made to settings in a form has been changed.
The settings made has been saved.
Alarm sounders in the system have been disabled.
The alarm sounders in the fire alarm system have been
enabled.
The split loop fault has cleared.
cleared
There is a split in the loop circuit wiring between end-1 and
alloc'd
end-2. Rectify the wiring fault.
The time and date settings at the panel have been adjusted.
adjusted
The time and date has not been set at the panel.
set
Set the time and date at the panel.
The processor controlling the control panel has failed.
Call servicing organisation to rectify the fault.
The fault associated with the panel microprocessor has
cleared
cleared.
The number of devices found on the loop have exceeded the
on loop
maximum limit.
Disconnect and remove devices from loop to within the
accepted maximum range.
This device type is not recognised.
type
The modified data on the form has not been saved. Press
enter to save the shanges or press any key to exit the form
any key
without saving the data.
Valid
The configuration remains valid after leaving access level 4.
This is a reminder message to carryout a weekly fire test on
the system.
A zone has been manually disabled.
A zone has been manually enabled.
The zone has been manually put into fire test state.