Gent System 800 Installer Manual page 66

Any service and maintenance work on the panel or system must be carried out by a
trained maintenance engineer from the fire alarm servicing organisation.
Message displayed Description and checks
Fire not reset
Fire protection
equipment fault
Fire protection
equipment OC
Fire protection
equipment SC
Fire routing
activated
Fire routing de-
activated
Fire routing
disabled /
Fire routing
output fault
Fire routing
output O/C or S/C
Fixed ext.
equipment fault
Hardware fault
during start up
Historic event
log erased
Incompatible
Invalid config
Invalid password
Labels cleared in
Left day mode
Security/customer
/engineering mode
Local input
disabled /
Local input fault
Local input O/C
or S/C fault
Local input test
66
796688 (4188-657)_i2 _06/03
Initial fire is still present or there is another fire.
Open or short circuit fault associated with the fire protection
circuit has been cleared.
cleared
There is an open circuit fault associated with the fire protection
equipment circuit.
Check the fire protection equipment wiring to the panel.
There is a short circuit fault associated with the fire protection
equipment circuit.
fault
Check the fire protection equipment wiring to the panel.
The fire routing equipment connected to the fire panel has
been manually activated.
The fire routing equipment connected to the fire panel has
been manually de-activated.
The output signal to fire routing equipment connected to the
panel is disabled / enabled.
enabled
The fault associated with the fire routing output has cleared.
cleared
There is an open / short circuit fault between the fire routing
equipment and the control panel. Check the wiring between
fault
the fire routing equipment and fire panel.
A fault associated with the fixed extinguishing equipment (fire
protection equipment) has cleared.
cleared
tba
The historic event log was erased.
The device installed on the loop does not have an isolater
device
fitted.
On exiting access level 4 the panel has found discrepency in
data
the configuration data. Check the panel configuration.
The password entered is not valid. Enter correct password.
EEPROM
The day mode timeout has expired.
Left
There has been an automatic return to access level 1 after a
duration of controls not being used. If required, manually re-
enter the apropriate access level.
The local input has been disabled / enabled.
enabled
The short or open circuit fault on the local input lines have
cleared
cleared.
There is an open/short circuit fault on the local input, which
can be class change, fire input or external evacuate circuit
wiring.
Check wiring between the external equipment and fire panel.
The local fire input has been manually put into fire test state.
fire
On completion of tests manually remove the test state from
the local fire input.