To Remove And Refit The Electronic Module; To Remove And Refit The Panel Door - Gent System 800 Installer Manual

To remove and refit the
electronic module
Earth lead Gland plate
Electronic module
To remove and refit the
panel door
Hinge pin Door
The electronic module should be removed from the backbox
to prevent building dust getting into the module.
Y
Remove the earth lead connected to the gland plate.
Y
Remove the five fixing screws that are used to secure
the electronic module to the backbox.
Y
Remove the electronic module from the backbox. Keep
the electronic module, earth lead and screws in a safe
place until required.
Y
To refit the electronic module: follow the procedure in
reverse order.
The hinged door on the panel may be removed from the
backbox to ease installation work.
Y
To remove the door: Hold the door and use a terminal
screwdriver to push out the two hinge pins, one at a
time.
Y
To re-fit the door: Hold the door to the back box and
with the hinge pins slot visible insert the pin into the
assembly until it click fits into position.
Hinge pin slot must be visible
796688 (4188-657)_i2 _06/03
11