Kostal PIKO Series Operating Manual page 93

Web server
1 2 3
Public line
GSM-PIN:
New log-inpassword:
Portal code
Data export
Fig. 55: Web server page "Settings" (Part 2)
Ser. no.: Inverter serial number.
1
Item number: Item number of the inverter.
2
Language: Selection of the language for the web
3
display.
Last name: Allocation of a name to the inverter.
4
WR bus (RS485) address:
5
RS485 address of the inverter.
Data capture: Selection of saving interval "every 15"
6
or "every 60" minutes.
Function Switch output (S0/AL-Out):
7
Setting possibilities: S0 pulse, alarm output, self-con-
sumption control, dynamic self-consumption control.
Self-consumption control:
8
Setting possibilities for the self-consumption function.
Detailed description in chapter Self-consumption.
Ch. 8.1
Function of analogue inputs: Two settings: Sen-
9
sors or active power control (connection of a ripple
control receiver).
Network: Configuration of the inverter network
10
interface (Ethernet). Detailed description in System
monitoring chapter.
Ch. 6
Public line: Only required when using an analogue
11
modem (optional accessory) and an analogue tele-
phone system.
GSM-PIN: PIN for the GSM modem SIM card.
12
New log-inpassword: Change of password.
13
03 / 2015 | DOC01361707 | KOSTAL operating manual PIKO inverter 3.0 - 20
4 5 6
(only for analogue modem and TC system)
Repeat:
Portal
2
3
7 8 9 10
The characters a–z, A–Z and 0–9 are
1
allowed for the name change. Spaces or
special characters are not possible. The
browser connection to the web server can
1
take place with the new name following
the name change. Access with the serial
number remains possible.
When two or more inverters are con-
2
nected via RS485, each inverter must be
given its own RS485 address.
When 15 minutes is selected, the data can
3
be saved for approximately 400 days. When
60 minutes is selected, the data can be
saved for approximately 1500 days. When
the internal memory is full, the oldest data
will be overwritten.
11 12
11
12
13
14
15
16
93