Kostal PIKO Series Operating Manual page 86

Web server
1 2 3
Connecting the inverter with a computer
De-energise the inverter.
1.
Open the inverter cover.
2.
Fig. 50: Connecting inverter and computer with an Ethernet cable
Inverter
1
Ethernet cable
2
Computer (for configuration or data retrieval)
3
Connect the Ethernet cable to the RJ45 interface of
3.
the communication board.
Connect the Ethernet cable to the computer.
4.
Close the inverter cover.
5.
Switch on the DC switch and the fuses.
6.
The inverter is connected to the computer.
H
03 / 2015 | DOC01361707 | KOSTAL operating manual PIKO inverter 3.0 - 20
4 5 6 7 8 9 10 11
TIP
You can find additional variants for
connecting the inverter with a
computer here:
DANGER
RISK OF DEATH DUE TO ELECTRI-
CAL SHOCK AND DISCHARGE!
De-energise the device, secure it
against being restarted and wait
five minutes so that the capacitors
can discharge.
Ch. 4.3
IMPORTANT
INFORMATION
If the computer and the inverter are
connected directly with an Ethernet
cable, the adjacent work sequence
must be followed!
TIP
The IP address is found in the inverter
menu under "Settings / Communica-
tion / Network settings 2".
Additional entry options in the ad-
dress line of the browser:
n S and the serial number of the
inverter on the type plate (example:
http://S12345FD323456)
n Name of the inverter: The inverter
can be assigned a name. This may
be no longer than 15 characters
and may not contain special char-
acters like + - * /... (For example:
http://SWR_5).
12
Ch. 6.1
86