Battery Indicator And Battery Change Batteries Almost Flat; Batteries Flat - Replacement; Which Batteries And Which Procedure; Using A Mains Adapter - Microlife aponorm Professionell 47034 Manual

9. Battery Indicator and Battery change
10.
Batteries almost flat
When the batteries are approximately ¾ used the battery symbol
AO will flash as soon as the instrument is switched on (partly filled
battery displayed). Although the instrument will continue to
measure reliably, you should obtain replacement batteries.
Batteries flat – replacement
When the batteries are flat, the battery symbol AO will flash as
soon as the instrument is switched on (flat battery displayed). You
cannot take any further measurements and must replace the
batteries.
1. Open the battery compartment 7 at the back of the instrument
by pushing inwards at the two arrows and pulling out the
battery compartment cover.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
3. To set date and time, follow the procedure described in
«Section 2.».
The memory retains all values although date and time (and
possibly also set alarm times) must be reset – the year
number therefore flashes automatically after the batteries
are replaced.

Which batteries and which procedure?

Please use 4 new, long-life 1.5V, size AA batteries.
Do not use batteries beyond their date of expiry.
Remove batteries, if the instrument is not going to be used
for a prolonged period.
Using rechargeable batteries
You can also operate this instrument using rechargeable batteries.
Please use only type «NiMH» reusable batteries!
The batteries must be removed and recharged, if the battery
symbol (battery flat) appears! They must not remain inside
the instrument, as they may become damaged (total
discharge as a result of low use of the instrument, even
when switched off).
Always remove the rechargeable batteries, if you do not
intend to use the instrument for a week or more!
18
The batteries can NOT be charged in the blood pressure
monitor! Recharge these batteries in an external charger
and observe the information regarding charging, care and
durability!

10. Using a Mains Adapter

11.
You can operate this instrument using the Microlife mains adapter
You can operate this instrument using the aponorm
(DC 6V, 600mA).
adapter (DC 6V, 600mA).
Use only the Microlife mains adapter available as an orig-
Use only the aponorm
inal accessory appropriate for your supply voltage, e.g. the
ble as an original accessory appropriate for your supply
«Microlife 230V adapter».
voltage, e.g. the «aponorm
Ensure that neither mains adapter nor cable are not
damaged.
1. Plug the adapter cable into the mains adapter socket 5 in the
blood pressure monitor.
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery current is
consumed.
12.

11. PC-Link Functions

This device can be used in connection with a personal computer
(PC) running the Microlife Blood Pressure Analyser (BPA) software.
The memory data can be transferred to the PC by connecting the
monitor via cable with the PC.

Installation and Data Transmission

1. Insert CD into CD ROM drive of your PC. The installation will
start automatically. If not, please click on «SETUP.EXE»
2. Connect the monitor via cable with the PC – no need to switch
the device on. Three horizontal bars will appear on the display
and last for 3 seconds.
3. The bars will then fl ash to indicate that the connection between
computer and device is successfully made. As long as the cable
is plugged, the bars will keep fl ashing and buttons are disabled.
During the connection, the device is completly controlled by the
computer. Please refer to the «help» fi le for software instructions.
® by microlife
®
by microlife mains adapter availa-
®
by microlife 230V adapter».
aponorm ® by