Nissei WSK-1011 Instruction Manual page 5

4. In case of cardiovascular diseases and a number of other diseases that require the blood pressure monitoring, measurements should
be carried out in the hours specifi ed by a doctor. REMEMBER THAT THE DIAGNOSTICS AND ANY TREATMENT OF ARTERIAL HYPERTENSION
SHOULD BE CARRIED OUT ONLY BY A DOCTOR BASED ON BLOOD PRESSURE READINGS OBTAINED BY A DOCTOR. MEDICAL DRUG ADMINIS-
TRATION OR CHANGE OF DOSAGES SHOULD BE MADE ONLY BY PRESCRIPTION OF AN ATTENDING DOCTOR.
5. In case of disorders such as deep vascular sclerosis, weak pulse wave and break in rhythm of heart contractions, the correct blood pressure
measurement can be complicated. IN THIS CASE, A DOCTOR SHALL PROVIDE RECOMMENDATIONS IN RELATION TO USE OF THIS DEVICE.
6. KEEP QUIET DURING THE MEASUREMENT TO OBTAIN THE CORRECT BLOOD PRESSURE READING WHEN USING THE ELECTRONIC DEVICE.
The blood pressure measurement should be carried out in a quiet comfortable atmosphere at room temperature. Exclude meal an hour be-
fore the measurement, and exclude smoking, soft drinks, and alcohol 1.5-2 hours before the measurement.
7. Accuracy of the blood pressure measurement depends on matching the device cuff and size of your hand. THE CUFF SHOULD NOT BE
TOO SMALL OR TOO BIG.
8. Repeated measurements are carried out at 5-minute intervals to recover the blood circulation. However, persons suff ering from severe
atherosclerosis, due to a signifi cant loss of elasticity of blood vessels, need longer intervals between measurements (10-15 minutes).
This also concerns patients suff ering from long-term diabetes. For more accurate determination of blood pressure it is recommended to carry out
a series of three consecutive measurements and to calculate the average value of measurement results.
POWER SUPPLY OF THE DEVICE
1. Disconnect the battery compartment (Fig.2).
2. Install two "AA" batteries in the compartment.
Make sure that polarity corresponds to signs (+) and (-) shown inside the
compartment (Fig. 3).
Batteries are readily installed by pressing the end "-" on the spring.
3. Close the battery compartment.
Do not use excessive force when removing the cover.
Fig.2 Fig.3
5