Ip Addresses - THOMSON SpeedTouch 605 User Manual

Chapter 5
Expert Configuration

5.3.1 IP Addresses

Overview
Add/change an IP
124
The IP address table shows all IP addresses configured on any of SpeedTouch™'s
interfaces.
In the table following information is provided per IP address:
The Interface to which the IP address applies
The IP address/Netmask (in prefix notation)
The IP address Type, being either:
auto, in case the address has been automatically assigned by the
SpeedTouch™ at startup or via negotiation
extra, in case of a manually configured IP address.
You can also assign additional new IP addresses to the SpeedTouch™ (see
change an IP
In case you select an IP address entry, you can:
Make changes to the IP address configuration (see
and click Apply.
Click Delete to delete the IP address.
To add a new IP address to the SpeedTouch™:
address
Click New.
1
Select the Interface to which the IP address must apply.
2
Either:
3
Type a valid IP address/mask (in prefix notation).
Select Obtain an IP address automatically.
Click Apply to add the IP address.
4
To change the configuration of an existing IP address:
Select the IP address entry.
1
Make your changes.
2
Click Apply.
3
address).
Add/
Add/change an IP address)
E-DOC-CTC-20050429-0104 v1.0