8.3 Reset to Factory Defaults
Resetting your
SpeedTouch™
Hardware reset
E-DOC-CTC-20050429-0104 v1.0
You might consider a reset to factory defaults as described below.
Be aware that a reset to factory defaults will revoke all configurational
!
changes you made to the SpeedTouch™.
You can choose between:
Hardware reset
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Also your WLAN clients will have to be re-associated, as described in
"2.2.2 Connecting First-time Wireless Clients" on page
Proceed as follows:
Make sure the SpeedTouch™ is powered on.
1
Use a pen or an unfolded paperclip to push the recessed reset button on the
2
back panel. The reset button is marked with a red circle. Keep it pushed until
the power LED lights red - this will take about 7 seconds.
ON
OFF
15VAC
Console
Release the reset button.
3
The SpeedTouch™ restarts.
4
Your system administrator may have disabled the physical reset button of
!
the SpeedTouch™. In this case, a hardware reset to defaults is not possible.
24.
Reset
Asso-
ciation
1
2
3 4
Chapter 8
Troubleshooting
ISDN
199