Table of Contents
Advertisement
Chapter 5
Expert Configuration
5.2.5 Syslog
Overview
Messages
Configuration
110
The Syslog page consists of two sections:
Messages
Configuration
This section allows to overview system log and alert messages your SpeedTouch™
generated during operation. System log messages are used to provide a historical
overview of events, errors, and messages generated during SpeedTouch™ operation.
Per message following information is shown:
Facility
Severity
The system message content (and time of generation)
By default the table is automatically refreshed every 30 seconds and shows all
system log messages.
Click Stop AutoRefresh to stop the automatic refreshing of the table.
The Message buffer view options menu becomes accessible to:
Select the
Facility
Select the
Severity
Change the Refresh rate of the table.
As long as AutoRefresh is disabled you can manually refresh the table by
clicking Refresh.
Click AutoRefresh to apply your changes and to start automatic update of the
table (using the new refresh rate).
This section allows you to view/configure remote destinations (syslog servers) to
send (a subset of) the SpeedTouch™ syslog messages for remote monitoring
purposes.
To add a destination:
In the Facility box, type the
1
In the Severity box, click the
2
In the Destination box, type a destination (IP address or host name) to send
3
the messages to.
Click Add.
4
level of syslog messages to show in the table.
level of syslog messages to show in the table.
Facility
of your choice.
Severity
of your choice.
E-DOC-CTC-20050429-0104 v1.0
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
