THOMSON SpeedTouch 605 User Manual page 156

Chapter 5
Expert Configuration
VLAN interface
configuration
146
Proceed as follows to add or remove Bridged Ethernet interfaces for a certain VLAN:
Select the VLAN you wish to edit.
1
A listing of all bridge interfaces will appear, each followed by a drop-down list.
2
Change the value of the drop-down list to add or remove interfaces from this
VLAN:
(none), which means that this interface is not a member of the selected
VLAN.
Tagged, which means that this interface is a member of the selected
VLAN, and that packets coming in and going out of the SpeedTouch™ will
be VLAN tagged.
Untagged, which means that this interface is a member of the selected
VLAN, but that the VLAN functionality will be not visible outside the
SpeedTouch™. This means that inside the SpeedTouch™ VLAN will be
used to isolate interfaces from each other, but that outside of the
SpeedTouch™ no VLAN tagging will be used.
Click Apply.
3
E-DOC-CTC-20050429-0104 v1.0