New Content Level - THOMSON SpeedTouch 605 User Manual

Chapter 4
Basic Configuration

4.5.9 New Content Level

Introduction
Procedure
Content level creation
Content level
configuration
Content level definition
78
This page allows you to create a new content level. To access this page:
On the Toolbox menu, click Parental Control.
1
In the upper right corner, click Configure.
2
Under Pick a task..., click Create a new content level.
3
To apply a new content level following actions must be performed:
Content level creation
1
Content level configuration
2
Content level definition
3
Content level activation
4
!
You can create up to 16 content levels.
Proceed as follows:
In the Name box, type a name for the new content level.
1
In the Description box, type a short text to describe what this security level will
2
do.
Click Next.
3
Proceed as follows:
The Configuration section becomes available.
1
Click:
2
Clone Existing Level to start from a previously created content level.
If no levels have been defined before, this option will not be
shown.
Black List to allow all web sites by default.
White List to block all web sites by default.
Click Next.
3
Only web sites that match the selected content level will be allowed. Proceed as
follows:
If you want to:
1
Allow a category:
Select the check box next to the category name.
Allow an entire group:
Select the check box next to the group name.
Block a category:
Clear the check box next to the category name.
Block an entire group:
Clear the check box next to the group name.
Click Apply.
2
E-DOC-CTC-20050429-0104 v1.0