Preparation For Riding; Making Adjustments; Inter Grip Seat Clamp Adjustment And Service - Whyte E-150 Operating Instructions And Owner's Manual

3.0: PREPARATIONS FOR RIDING

3.1: MAKING ADJUSTMENTS

Please refer to the specific component
manufacturers manual or published tech-
nical information about adjusting, servic-
ing or replacing the components on your
Whyte bike. Instructions may be down-
loaded from the relevant manufacturer's
internet website, as shown in the table to
the right.
In addition, we recommend that you
should also read carefully the advice pub-
lished by Bosch e-bike systems about
operation of the Bosch e-Bike systems
fitted to the Whyte e-MTB. Failure to do
so could result in Serious Injury or Death.
For additional advice on general care of e-
bikes, Visit:
www.bosch-ebike.com/en/news/care-of-ebikes/
CAUTION! If you are uncertain in any way, about making adjustments to
any components or systems on you Whyte bike, then DO NOT RIDE YOUR
BIKE. Contact your Whyte dealer who will be able to advise you on how to
go about setting up you Whyte bike for riding, and or making adjustments
to the components fitted to your Whyte bike.
3.2: WHYTE INTER GRIP SEAT CLAMP ADJUSTMENT & SERVICE
Tools Required:
Lithium
Complex grease
The Inter Grip seat clamp design is present on some models of Whyte full suspen-
sion mountain bikes. It allows adjustment of the saddle height & direction.
CAUTION! Avoid over-tightening the seat clamp.
In particular, "dropper" Seat Posts may not work correctly if the seat clamp
is over tightened.
2019
WHYTE Service Manual
5mm Hex Key
Torque Wrench (Ranging from 3Nm to 15Nm)
SKF LGEP2 or Castrol Spheerol AP3 or Finish Line Teflon White
Bosch www.bosch-ebike.com
Crank www.crankbrothers.com
Brothers
DT Swiss www.dtswiss.com
Formula www.formulahubs.com
Fox www.foxracingshox.com
Joytech www.joytech.co.tw
Maxxis www.maxxis.com
Race Face www.raceface.com
SR Suntour www.srsuntour-cycling.com
SRAM www.sram.com
WTB www.wtb.com
Page 5