Related Manuals for Whyte e-MTB HardTail Series
Summary of Contents for Whyte e-MTB HardTail Series
- Page 1 e-MTB HardTail Range e-504: 27.5” eMTB Hardtail e-505: 29” eMTB Hardtail e-506: 27.5” eSUV Supplementary Service Manual 2021 Edition 1...
-
Page 2: Table Of Contents
Seat Clamp Adjustments. Set up of Fork Safety. Lubrication: General Lubrication Servicing the Whyte Modular Dropout Systems: Whyte 12mm QR Shaft Removal of Bosch Power Tube Battery DownTube Plastic Battery Cover Removal and Installation: Location of Bosch Battery On/Off Button. -
Page 3: Introduction
NOT RIDE YOUR BIKE. Contact your Whyte dealer who will be able to advise you on how to go about setting up you Whyte bike for riding, and or mak- ing adjustments to the components fitted to your Whyte bike. -
Page 4: Set Up Of Fork
To set Sag on the front fork, you need to measure the amount the fork compresses when you sit on the bike in the normal riding position. See the table on the right for our recommendation of front fork sag on your Whyte bike. To achieve this you will need to adjust the air spring pressure inside the fork. -
Page 5: Safety
4.0: SAFETY IMPORTANT: The following are intended to be advisory notes on the safe use of your Whyte bike. You should also read thor- oughly the General Instruction Manual also supplied with your new bike. If at any stage you are uncertain about the safety or safe operation of the bike as a whole, or any specific component, then DO NOT RIDE YOUR WHYTE and instead please con- sult the specific component manufacturers instruction manual or your Whyte Dealer for advice. -
Page 6: Servicing The Whyte Modular Dropout Systems
WARNING: If you are unsure about how tight the axle needs to be done up to, DO NOT ride your bike and instead consult your Whyte Dealer who will be able to advise and demonstrate the correct closing force. Ensure that the lever is back to its normal position after every adjustment is made. To do this, pull the spring-loaded ever arm away from the bike (Fig. -
Page 7: Removal Of Bosch Power Tube Battery
Down Tube of the frame. You can then access the standard Bosch PowerTube Locker which is located on the side of the DownTube of the e-bike frame as shown in Fig. 3a. Peel back and remove the Whyte covering bung, taking care not to loose it. -
Page 8: Location Of Bosch Battery Charge Port
The position of the remote charge port for the Bosch Battery has been integrated into the side of the Motor Mount as can be seen in Fig.7 and Fig.8. To access the charge port, peel back the sealed cover of the Charge Port marked “Whyte Energy” to reveal the charge port. -
Page 9: Torque Settings
8.0: TORQUE SETTINGS Torque explained: If no suitable Torque Wrench is available a Torque of 5 lbf.ft can be obtained by applying a force of 5lb, with a Spring Balance, to the end of a spanner, 1 Foot in length. IMPORTANT: For all other torque settings, refer to the specific manufacturers information bundled with this manual, or alterna- tively, refer to the specific manufacturers website for further information.