Whyte E-150 Operating Instructions And Owner's Manual page 31

CAUTION: Before installing the seat-post, carefully consult the product
manufacturer's own instructions.
Reference figure 42. First prise out the two blank plastic covers near the bottom
bracket with a small screwdriver.
Reference figure 43. Carefully unscrew the hose from the remote actuator.
Reference figure 44. Insert the disconnected hose end into the top of the seat tube
and push down towards the bottom bracket.
Reference figure 45. Manoeuvre the hose end out of the slot at the front of the seat
tube.
Reference figure 46. Push two rubber grommets over the end of the hose.
sure the narrower end of the first grommet is facing the seat tube, whilst the narrow-
er end of the second grommet is facing the down tube.
Reference figure 47. Insert the hose end into the down tube and push the hose up
towards the head tube. The grommets will have to be pushed further along the hose
to do this.
Reference figure 48. Prise out the rubber grommet on the side of the down-tube,
near the head tube, with a small screwdriver.
Reference figure 49. Manoeuvre the hose end out of the slot at the top of the down
tube. Use a small hook to assist with capturing the hose end and drawing it towards
the slot. A torch would help to locate the hose end.
Reference figure 50. Push the rubber grommet over the end of the hose. Make sure
the narrower end of the grommet is facing the down tube.
Reference figure 51. Insert the seat-post into the seat tube and simultaneously pull
the hose through the frame.
Reference figure 52. Insert all three rubber grommets into the frame slots. Use a
small screwdriver with care not to split the rubber.
Reference figure 53. Cut the hose to length and follow the product manufacturer's
instructions to re-assemble and bleed the hydraulic system.
Page 30
WHYTE Service Manual
Make
2019