Set Up Of Fork - Whyte E-150 Operating Instructions And Owner's Manual

Ite
Description
m
Cap-screw, M6 x 30mm
1
long.
Inter-Grip Sleeve,
2
threaded.
"O" Ring seal, fits in
3
sleeve groove.
Inter-Grip Sleeve, no
4
thread.
Inter-Grip Pad for
5
Ø30.9mm Seat Post.
To adjust the Seat height and/or direction, using the 5mm Hex Key, undo the M6
Capscrew (1) just enough to allow the Seat Post to slide freely up and down. Set the
height and/or direction to the desired level. Re-tighten the M6 Capscrew (1), using
the 5mm Hex Key and Torque Wrench, to the 14Nm limit, as marked on the Plain
Sleeve (4).
If a "dropper" Seat Post is fitted, simultaneously depress the activation trigger and
press down on the Saddle to compress the Seat Post until it is fully compressed. Then
release the activation trigger and the Seat Post should rise up automatically. If this
does not happen, gradually loosen the M6 Capscrew (1) with the %mm Hex Key be-
low the 14Nm limit, until the Seat Post rises automatically. Then firmly twist the Sad-
dle to confirm the Seat Post is still securely gripped by the lowered torque value that
allows the "dropper" Seat Post to function correctly.
CAUTION!
insertion depth requirement marked on the Seat Post. Also consult the manu-
facturers Seat Post instructions in conjunction with these notes.

3.3: SET UP OF FORK

Tools Required:
The Front Suspension Fork fitted to your Whyte bike will be pre-set with the standard
settings. Before riding, you may need to adjust these setting. First is the Sag setting
on the fork. This is to ensure the forks are set-up correctly for your own body weight,
allowing the fork to perform as intended.
To set Sag on the Fork, you need to measure the amount the Fork compresses when
you sit on the bike in the normal riding position.
Refer to the specification tables in the relevant Fork manufacturers set up instruc-
Page 6
WHYTE Service Manual
Fig.1: Inter-Grip Seat Clamp
When adjusting the saddle height you MUST obey the Minimum
Good Quality Shock Pump.
Small Ruler
2019