Table of Contents
Advertisement
Insert two 1/2'-' flange bearings~ into the leg curl extension~ a~ shown. Assemble the leg curl extension ~
to the front upright® using one 1/2 x 3" bolt@ and one 112" low height nylock nut ~ as shown, (Note:
Tighten this connection enough to remove excess play yet allowing leg curl extensiar~ ta rotate freeh/.)
B. Assemble the swivel pulley bracket® to the base@ using one 1/2" low. height nylack nut~ as shown.
(Note: Tighten this connection enough to remove excess play yet allowing swivel pulley bracket to
rotate freely.)
C. ~lid~ one 4 x 12" roller pad@ onto both .the right pec arm® and left pec arm ® until flush with bottom
of arm. (N~te: Spraying the inside of roller pads with household window cleaner will make the roller
pads slide.on easier.)
D. Assemble the ril]ht pe¢ arm ® to the bearing housing ~ using two 3/4" flange bearinl]s@ and one 3/4"
capnut ~ as shown. (Note:. The 3/4" capnut can be tapped onto the shaft of the pec arm usin~ ~. rubber
mallet.)
E." Assemble the left pec arm ® to the bearin~ housing ® usin~ two 3/4" flanl~e bearings @ and one 3/4"
¯ capnut ~ as shown. (Note: The 3/4" capnut canbe tapped ont.o the shaft of the p,ec arm usinl] a rubber
r~allet.)
F. Apply two 1 x 1" glides @ to the bearing housin~ where the pec arm cams co~r~e in contact with the
bearing housin~ as shown.
Frame
Assembly
- S~p 6
Hide quick links:
Advertisement
Table of Contents
