ParaBody 350 Assembly Instructions Manual page 12

Step 2
,~. Securely assemble the weight stack ~abl~@ .and one 3-~/2" pulleyS) to thetop boom .~ using one 3/8
× "1-3/4" bolt@ and one 3/8" nylock nut@ as showm (Note: Loop the cable over the pulley prior.to.
inse~ting it into the pulley bracket on the top boom.)
B. Screw the threac]ed end of the weight stack cable@ approximately 3/4" into the en,:] of the selector
shaft @ and tighten jam nut securely as shown.
C. Securely assemble one 4-1/2" pulley @ to the floating pulley(~ using one 3/8 x 1-3j4'" bolt @ and one
¯ 3/8" nylock nut ~ as shown. Hang this assembly over the .weight ~tack cable @ as shown.
Weight Stack Cable Assembly - Step 2