Table of Contents
Advertisement
FIGURE 1
Step 1
.
.
¯
For maximum performance, the HEAD PLATE (62) should just barely sit on the top WEIGHT PLATE (76)
the FLOATING
PULLEY BRACKET
(19) should firmly contact the PLATE on the FRONT UPRIGHT
(10). See FIGURE
¯
If upon completion of assembly, the HEAD PLATE (62) does not sit on top of the first WEIGHT
PLATE (76),
the HEAD PLATE (62) down, insert the WEIGHT
STACK PIN (35) and perform several repetitions at the press
station. This will relax the cable system and prevent the HEAD PLATE (62) from liftinl~ up. See FIGURE
¯
Tension in the WEIGHT STACK CABLE (73) .can be made by adjustin8 both the threaded ends of the CABLE
the SELECTOR
SHAFT (63) and at the ADJUSTABLE
GLIDE (40) on the FP..ON'I" UPRIGHT.
¯
Tension in the LEG CURL EXTENSION
CABLE (71), the PEC CABLE (70), and the AB CABLE (72:) can be made by adjustin~
the U-BRACKET
(1) and AB :CABLE
(72) connection
and by rnovini~ the pulleys closer or further apart in the PLATE
ASSEMBLY
(20).
Hide quick links:
Advertisement
Table of Contents
