Table of Contents
Advertisement
S~ep 2
.
.
. . ¯
A. Securely assemble the weight stack cabl~ @ and one 3-I/2" pulley~) to the top boom ® using one 3/8
x 1-314" bolt @ and one 318" nylock nut @ as shown. (Note: Loop the cable over the pulley prior.to~
inserting it into the pulley bracket on the top boom.)
B. Screw the threaded end of the weight stack cable@ approximately 314" into the end of the selector
shaft @ and tighten jam nut securely as. shown.
C. Secu~'ely assemble one 4-1i2" pulley @ to the floating pulley@ using one 318 x 1-314" bolt @ and one
318" nylock nut ~ as shown. Hang this assembly over the weight_ Stack cable @ as shown.
Weight Stack Cable Assembly - Step 2
Hide quick links:
Advertisement
Table of Contents
