Table of Contents
Advertisement
A. Insert two 1/2 '.~ flange bearingsO into the leg curl extension@ as shown. Assemble the leg curl extension ®
to the front upright@ using one 1/2 x 3" bolt@ anti one 1/2" low height nylock nut ~ as shown. (Note:
Tighten this connection enough to remove excess play yet allowing leg curl extension to rotate freely.)
B. Assemble the swivel pulley bracket® to the base@ using one 1/2" low height nylc,ck nut@ as shown.
(Note: Tighten this connection enough to remove excess play yet allowing swivel pulley bracket to
rotate freely.)
C. $1id~ one 4 x 12" roller pad @ onto both .the .right pec arm ® and left pec arm ® un~il flush with bottom
of arm, (Note: Spraying the inside of roller pads with household window cleaner will make the roller
pads slide, on easier.)
D, Assemble the right pec arm ® to the bearing housing@ using two 3/4" flange bearings@ and one 3/4"
capnut @ as shown, (Note:- The 314" capnut can be tapped onto the shaft of the pec arm using a rubber
mallet.)
E. Assemble the left pec arm ® to the bearing housing @ using two 3/4" flange bearings @ and one 3/4"
c, apnut @ as shown. (Note: The 3/4" capnut canbe tapped onto the shaft of the pec arm using a rubber
mallet.)
R Apply two 1 x 1" glides @ to the bearing housing ~ where the pec arm cams come in contact with the
bearing housing as shown.
Frame Assembly - S~p ~
/25/97
Hide quick links:
Advertisement
Table of Contents
