ParaBody 350 Assembly Instructions Manual page 6

A. Slide the top boom ® over the ends of both guide rods ® and loosely assembleit to the: front upright@
using two 1/2 x 4" bolts@, two 1/2" flat washers@, and two 1/2" nylock nuts@ as shown.
B. Loosely assemble the.bearing housing@ to the rear upright @ and the top boom® using two 1/2 x 3"
bolts@ as shown. (NOTE: Install these bolts carefully to avoid stripping the internal the'earls of the .top
boom and bearing housing.)
C. At this tim~, securely, tighten all frame connections ih this order: bearing housing@ to rear uprightS)
and ~op boom 6), rear upright @ to base@, top boom ® to front upright~, and front uprilght ~ to base@.
Frame Assembler - Step :3 ...