Table of Contents
Advertisement
A. Instal] two set screws@ into the top of the press arm® as..shown. (Note: Tighten each set screw only
one turn at this time.)
B. Insert two 3/4" flange bearings@ into the top boom® as shown.
C. Screw the adjustable glide@ approximately 1/2" into front upright@ and tighten jam nut securely as
shown.
D. Att~ich the press arm® to the top boom® using the 314 x 7" shaft@ as shown. Al~gn the holes in the
press arm witl~ the 314" flange bearings and tap the shaft in place With a rubber mallet. The shaft sl~ould
be flush with the outer edges of the press arm.
-
E. Loosely assemble two 4-I/2" pulleys@ to the press arm® using two 3/8 x 7-112" bolts@, 'four 318" flat
washers@, four 3/8 x I" spacers@, and two 3f8" low height nylock nuts@ as shown. Once both pulleys
are installed, you may securely tighten these two connections.
F. Securely tighten.t__he two set screws @ and insert two 2" square end caps@ into open ends of the press
arm ® as show.n.
F~ame Assembly- Step 4
Revisio~.~ ~ "1/25/97
Hide quick links:
Advertisement
Table of Contents
