Installation Of The Product - Husqvarna 430XH Operator's Manual

3.3.5 Work area examples
D
B
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 3 m / 10 ft.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.5 ft. If the passage is
smaller than 2 m / 6.5 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by a narrow passage (B), you
can set the product to leave the guide wire
after a certain distance (C). The settings can
Lawn coverage on page 27 .
be changed in
• Use the GPS Assisted Navigation. Refer to
Lawn coverage on page 27 .
• If the work area includes a secondary area
To make a secondary area on
(D), refer to
page 19 . Put the product in the secondary
Secondary area mode .
area and select
Secondary area on page 34 .
Refer to
20 - Installation

3.4 Installation of the product

3.4.1 To install the charging station
1. Read and understand the instructions about
the charging station. Refer to
A
where to put the charging station on page
16 .
2. Put the charging station in the selected area.
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in.
C
5. Connect the power supply cable to a
100-240V outdoor power outlet.
WARNING: Obey national regulations
about electrical safety.
To examine
min 30 cm / 12"
CAUTION: The product is only to
be used with the power supply
unit supplied by Husqvarna.
WARNING: Do not put the power
supply at a height where there is a
risk it can be put in water. Do not
put the power supply on the
ground.
WARNING: Do not encapsulate
the power supply. Condensed
water can harm the power supply
and increase the risk of electrical
shock.
1230 - 001 -