Husqvarna 430XH Operator's Manual page 46

Message Cause
Guide 1 not found
The guide wire is not connected to the
charging station.
Guide 2 not found
Guide 3 not found
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Guide calibration
The product has failed to calibrate the
failed
guide wire.
Guide calibration
The product has succeeded to calibrate
accomplished
the guide wire.
GPS navigation
Problem with the GPS assisted naviga-
problem
tion equipment.
Weak GPS signal
The GPS signal is weak for the current
work area. GPS assisted navigation
cannot be used.
Difficult finding
The product has been following the
home boundary wire several laps without find-
ing the charging station.
Temporary prob-
Please try again.
lem with the serv-
er.
Connection prob-
Problem with the Automower
lems
module
Connection set-
Settings for wireless connectivity have
tings restored
been restored due to an error.
46 - Troubleshooting
Action
Check that the guide wire's connector
is tightly connected to the charging sta-
tion. Refer to
on page 21 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 21 .
Check that the guide wires are installed
according to the instructions. Refer to
To install the guide wire on page 21 .
No action required.
Contact your local Husqvarna repre-
sentative if this message appears of-
ten.
If the message appears often, disable
the GPS assisted navigation and in-
stead use the manual settings for Lawn
coverage. Refer to
ble the GPS function on page 27 .
The installation has not been done cor-
rectly. Refer to
Wrong corridor width setting on boun-
dary wire. Refer to
width on page 29 .
The product was started on a Secon-
dary area with the Main area setting.
Contact your local Husqvarna repre-
sentative if this message appears of-
ten.
®
Connect Restart the product. If there still is a
connection problem, try to unpair the
(My mowers) and then pair it
product
again. If the problem remains, contact
your local Husqvarna representative.
Check and revise settings if necessary.
To install the guide wire
To disable and ena-
Installation on page 16 .
To set the corridor
1230 - 001 -