7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
•
Obey all applicable national regulations.
•
Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
7.2 Storage
•
Fully charge the product. Refer to
the battery on page 35 .
•
Disconnect the product with the main switch.
To switch off the product on page
Refer to
35 .
•
Clean the product. Refer to
product on page 37 .
•
Keep the product in a dry, frost free space.
•
Keep the product with all wheels on level
ground during storage, or use a Husqvarna
wall hanger.
•
If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a container with grease.
Note: If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
7.3 Disposal
•
Obey the local recycling requirements and
applicable regulations.
•
For questions about how to remove the
battery, refer to
To remove the battery on
page 53 .
7.3.1 To remove the battery
CAUTION: Only remove the battery
when you dispose the product. When
you remove the warranty seal, the
Husqvarna warranty is no longer
applicable.
1230 - 001 -
1.
2.
3.
4.
To charge
Clean the
5.
6.
7.
8.
9.
10. Open the battery cover and remove the
Switch off the product. Refer to
on page 34 .
Pull out the grommet on the charging cable
at the very front of the product, and carefully
remove the connector.
Lift the cover, one corner at a time.
Remove the 14 screws with a Torx 20.
Lift the rear edge of the top section of the
chassis.
Disconnect the cable from the main circuit
board.
Remove the top section of the chassis.
Remove the 3 screws that holds the battery
with a Torx 20.
Disconnect the battery connection from the
main circuit board.
battery.
Transportation, storage and disposal
Main switch
- 53