Operating Mode - Park; To Stop The Product; To Switch Off The Product; To Charge The Battery - Husqvarna 430XH Operator's Manual

If the product charges in the
mode, it will fully charge, move out about 50 cm /
20 in. and then stop. This means that the product
is charged and prepared to start to cut.
Note: It is recommended to change the operation
Main area before you put the product
selection to
in the charging station.
4.3.4 Spot cutting
Spot cutting means that the product mows in a
spiral pattern in order to cut the grass in the area
where it was started. You can select how the
product must continue to operate when cutting is
complete.
• Use the right arrow button to select
Area or Secondary Area .

4.4 Operating mode - Park

Park the following operation
When selecting
selections can be selected:
• Park until further notice
• Start again in 3 hours
• Start with next timer
4.4.1 Park until further notice
The product stays in the charging station until
another operating mode is selected by pressing
the START button.
4.4.2 Start again in 3 hours
The product stays in the charging station for 3
hours and then automatically goes back to the
usual operation. This operation selection is
applicable when it is necessary to pause
operation.
4.4.3 Start with next timer
The product stays in the charging station and
starts to operate on the next

4.5 To stop the product

1. Press the STOP button on top of the
product.
The product stops and the blade motor stops.
1230 - 001 -
Secondary area

4.6 To switch off the product

1.
2.
Main

4.7 To charge the battery

When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
mode, the product automatically alternates
between mowing and charging.
Timer setting.
1.
2.
3.
Press the STOP button on top of the
product.
Set the Main switch to position
WARNING: Always switch off the
product using the main switch if it
requires maintenance, or if the product
must be moved outside the work area.
WARNING: Only charge the product
using a charging station and a power
supply which is intended for it.
Incorrect use may result in electric
shock, overheating or leakage of
corrosive liquid from the battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
Set the Main switch to position
Place the product in the charging station.
Open the hatch and slide the product in as
far as possible to ensure proper contact
between the product and the charging
station.
0 .
Main area
1 .
Operation - 35