Husqvarna 430XH Operator's Manual page 41

Message Cause
No loop signal
The power supply is not connected.
The low voltage cable is damaged or
not connected.
The boundary wire is not connected to
the charging station.
Boundary wire broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
The boundary wire is laid in the wrong
direction around an island.
The connection between the product
and the charging station has been bro-
ken.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
1230 - 001 -
Action
Check the wall socket connection and
whether an earth-fault breaker has trip-
ped or not. Check that the low voltage
cable is connected to the charging sta-
tion.
Check that the low voltage cable is not
damaged. Check that it is also properly
connected to the charging station and
to the power supply.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
To install the boundary
aged. Refer to
wire on page 21 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
Finding breaks in
nal coupler. Refer to
the loop wire on page 50 .
Place the product in the charging sta-
tion and start the product again. Refer
To start the product on page 34 .
to
Check that the boundary wire was laid
according to instructions, e.g. in the
right direction around the island. Refer
Before the installation of the product
to
on page 16 .
Place the product in the charging sta-
tion and generate a new loop signal.
To create a New loop signal
Refer to
on page 26 .
Try moving the boundary wire.
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
Troubleshooting - 41