Husqvarna 430XH Operator's Manual page 31

2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use > Profile A, B or C .
3. Select a profile and push the OK button.
Save and push the OK button.
4. Select
Note: If the settings that are not stored to the
profile are made, the symbol * is shown beside
the profile name.
To use a profile
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Profiles > Use > Profile A, B or C > Select.
3.10.8.2 ECO mode
ECO mode stops the signal in the boundary loop,
the guide wire and the charging station, when the
product is parked or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: Push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
ECO mode .
3. Push the OK button to select
3.10.8.3 Spiral Cutting
The product cuts the grass in a spiral pattern if
the grass is longer in an area.
be set in 5 levels:
• Low-
• Low
• Mid
• High
• High+
1230 - 001 -
The level sets how sensitive the product is to
Settings > changes in grass height.
Note:
area mode. Cutting in the
does not let the product to start
Spiral Cutting does not start in slopes steeper
than 15%.
To set the level of Spiral Cutting
1.
2.
Settings >
3.
3.10.8.4 Slope Control
The
in slopes.
settings.
To enable or disable the Slope control
1.
2.
3.10.8.5 General
In
of the product.
To set the time & date
1.
Settings >
2.
ECO mode .
3.
Spiral cutting can
4.
5.
6.
Spiral cutting is only started in the Main
Secondary area mode
To get access to the menu
Do steps 1–3 in
on page 24 .
Use the arrow buttons and the OK button to
move through the menu structure
Spiral Cutting > Use > Intensity .
Use the arrow buttons to select the level of
Spiral Cutting .
Slope Control function decreases lawn wear
Slope Control is enabled in the factory
Do steps 1–3 in To get access to the menu
on page 24 .
Use the arrow buttons and the OK button to
move through the menu structure
Slope control > Use .
General you can change the general settings
To get access to the menu
Do steps 1–3 in
on page 24 .
Use the arrow buttons and the OK button to
move through the menu structure
General > Time & Date .
Use the number buttons to set the time and
then push the BACK button.
Use the number buttons to set the date and
then push the BACK button.
Use the arrow buttons to set the time format
and then push the BACK button.
Use the arrow buttons to set the date format
and then push the BACK button.
Spiral cutting .
Settings >
Settings >
Settings >
Installation - 31