Husqvarna 430XH Operator's Manual page 28

the distance from the charging station on
page 28 .
6. Push the number buttons to select the
distance, measured in m.
7. Use the number buttons to select the % of
the cutting time the product must cut the
area. The % is equal to the percentage of
the area in relation to the complete work
area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
20%
30%
To do a test of the Lawn coverage function
1. Put the product in the charging station.
To get access to the menu on
2. Do step 1-3 in
page 24 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-5 > More > Test .
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
To measure the distance from the charging
station
1. Put the product in the charging station.
To get access to the menu
2. Do steps 1–3 in
on page 24 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-5 > How far?
4. Use the number buttons to set m as a
distance.
28 - Installation
5. Push the OK button.
6. Push the BACK button.
7. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-5 > More > Test .
8. Push the OK button.
9. Push the START button and close the hatch.
10. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
To disable or enable the Lawn coverage function
Disable the
area.
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn coverage > Area 1-5 > Disable .
3. Use the left arrow button to disable or
enable the
4. Push the OK button.
5. Push the BACK button.
3.10.7.2 Finding the charging station
The product can be set to search for the charging
station in one or more of the following three
ways:
1. Charging station signal
2. Follow boundary wire
3. Follow guide wire
Installation
The default settings are set so that these 3
search options are combined to find the charging
station as fast as possible, but also with a
minimum risk of tracks forming on the lawn. The
product always starts by searching for the
Charging station signal . After a specified time
delay, it also uses
boundary wire .
Common causes why the product cannot follow
the wire are:
• Obstacles close to the wire have not been
isolated.
• The charging station, the boundary wire or
Installation the guide wire is not installed in accordance
with the instructions in
charging station on page 20 , To install the
Lawn coverage function for each
To get access to the menu
Lawn coverage function.
Follow guide and Follow
To install the
1230 - 001 -
Installation
Installation