Operation; Main Switch; To Start The Product; Operating Mode - Start - Husqvarna 430XH Operator's Manual

4.1 Main switch

WARNING: Read the safety
instructions carefully before you start
the product.
WARNING: Keep your hands and feet
away from the rotating blades. Never
put your hands or feet close to or
under the product when the motor is
running.
WARNING: Do not use the product
when persons, especially children, or
animals, are in the work area.
• Set the Main switch in the
the product.
• Set the Main switch in the
the product is not in use or before any work,
inspection or maintenance is being carried
out.
When the Main switch is set in the
the motors on the product cannot start.

4.2 To start the product

1. Press the STOP button to open the hatch.
2. Set the main switch to position
3. Enter the PIN code.
4. Press the START button.

34 - Operation

4 Operation
5.
6.
Note: Always press the START button before
closing the hatch to start the product.

4.3 Operating mode - Start

When the START button has been pushed the
following operation selections can be selected.
1 position to start
•
•
0 position when
•
•
4.3.1 Main area
0 position
Main area is the standard operating mode where
the product mows and charges automatically.
4.3.2 Override timer
The timer settings can be temporarily overridden
1 . by selecting
override the timer for 24 h or 3 days.
4.3.3 Secondary area
In the
operates until the battery is empty.
When the battery is empty, the product stops and
the message
the product display. Put the product in the
charging station to charge the battery.
Select the desired operating mode. Refer to
Operating mode - Start on page 34 .
Close the hatch within 10 seconds.
If the product is parked in the charging
station, it will only leave the charging station
when the battery is fully charged and if the
timer is set to allow the product to operate.
Main area
Secondary area
Override timer
Spot cutting
Override timer . It is possible to
Secondary area mode, the product
Needs manual charging shows in
1230 - 001 -